Installation guide

5.3. Setting Network
5.3.1. When connected to Ethernet
When WebEye 2.0 E10 is connected to Ethernet, set IP address and another information in “Network” tab.
Setting IP address manually
(1) Enter IP address.
(2) Enter subnet mask.
(3) Enter gateway.
(4) Enter DNS.
(5) Enter the “Apply” button.
Setting IP address automatically
(1) Check “DHCP Enable”.
(2) Press the “Apply” button.
<Note>
1. If checking “DHCP Enable”, WRS should be set.
2. When using cable modem or xDSL (automatic access modem), set it as “Ethernet” type.
5.3.2. When connected to xDSL
When WebEye 2.0 E10 is connected to xDSL line, set as follows then connect to xDSL line.
(1) Select “xDSL” type in “Network” tab.
(2) Enter ID and password for connecting to xDSL.
(3) Press the “Apply” button.
<Note>
1. xDSL has three kinds; ADSL, HDSL, and VDSL It can be used, when using PPPoE protocol.
2. When setting Network with xDSL, WRS menu should be set. (except using static IP)
3. If Network is set as xDSL type, Ethernet can’t be connected.
4. User’s ID and password is supplied from each xDSL ISP.
5. When using automatic connecting modem, even though Network line is xDSL type, a value should be
set as Ethernet.
5.3.3. When connected to PSTN
When WebEye 2.0 E10 is connected to PSTN line, Dial In/Out function is possible.
When sending event or periodic E-Mail, FTP, Dial Out function runs. When accessing WebEye 2.0 E10
that is connected through PSTN, Dial In function runs.
16