Installation guide

5.2. Changing IP address & Login
After connecting WebEye 2.0 E10 to Network, its IP address should be changed according to each
Network environment to access WebEye 2.0 E10 normally.
(1) Run WebEye 2. ConfigStation Tool in PC.
(2) Every WebEye 2.0, which is connected to local Network, is displayed in “Local Area Units”.
(3) Register WebEye at “My Units”.
(4) Move to “Network” tab in “Connectivity” menu.
(5) Set IP Address, Subnet Mask, and DNS.
(6) Press the “Apply” button after setting.
<Note>
1. The default password of admin is “admin”.
15