Installation guide

5.1.2. Connecting to local Network
(1) Connect WebEye 2.0 E10 to HUB with direct cable.
(2) Connect the supplied AC adaptor to WebEye 2.0 E10.
<Note>
1. To prevent WebEye 2.0 E10’s damage, you should connect power cable after connecting Ethernet
cable.
2. Ethernet cable should be pushed and connected, If not, noise may be occurred.
3. Check the LED of WebEye 2.0 E10 after supplying power.
Network status Yellow LED Green LED
Connected
It is on for the first 1-2 seconds,
and it blinks once per second.
Disconnected
It is on for the first 4-5 seconds and it
goes off. Then it keeps blinking fastly.
It is on for the first 1-2 seconds,
and it blinks once per 2 seconds.
14