User`s guide

- 45 –
WebEye SPD User’s Guide
(Appendix 4)
Updating WebEye SPD Firmware
Warning
This process is to update the current firmware that is already installed into your WebEye
with a new updated firmware.
If you are to begin the process, wait until the ‘Loading complete’ message appears. And
during the process, do not give physical shock nor disconnect network and power.
Otherwise, your WebEye can be damaged seriously, which may result inappropriate
operation or operation failure.
If you failed to update WebEye firmware or WebEye does not operate properly after
updating process, contact WGI distributor in your area.
1. Connect WeEye SPD to a PC.
When you do updating, it is strongly recommended to connect WebEye to a PC directly using a
crossover cable.
If a crossover cable is not available you may do the process with a direct cable connected a
HUB(LAN). When you do updating on LAN, your WebEye and a PC should be connected on local
network.
* You may also do the process on remote network.
Crossover cable
Direct cable