Installation guide

2.3.7 NVS04 connection
2.3.7.1 Connecting with DVR
(1) Connect to DVR as shown in the picture below using Gigabit Ethernet Cable.
(2) Connect DVR Port of NVS04R and Storage Port of DVR directly..
<Note>
1) The network cable connected to DVR should be Gigabit Ethernet Cable (Category-6). If not,
it is not connected to DVR.
2.3.7.2 Set ID Configuration
Set ID using Rotary Switch located on the back. This ID is used as IP Address of NVS04R and
the form of IP address is 10.10.20.XXX. when the user connect more than 2 units of NVS04R,
each ID should be set differently.