Installation guide

Installaction & User Manual
34
2.3 Connecting and configuring DIO ports
2.3.1 Wire Handlin
When connecting a wire to a terminal block, follow the instruction below. Not the different types
of wire that can be used.
- Standard wire: Pie off the wiring cover 8~10mm and solder it. Wire gage should AWG 22~26.
- Sold wire : Peel off the wiring cover 8~10mm and solder it. Wire gage should be AWG
20~26.
2.3.2 Inserting & removing wire
To insert & remove wire in Terminal Block, use a screw driver in the diagram like below.