User`s manual

8
- MANUAL : User can select color temperature among
3300°K, 4300°K, 7600°K and adjust the details by
KELVIN, R-GAIN and B-GAIN value.
CHROMA
(10, 0~20)
Adjust Chroma level.
IMAGE SHARPNESS
(5, 0~10)
Adjust sharpness. The higher value will show more
clear video image
H-MIRROR Mirror image. Left and right will be reversed.
V-MIRROR Flip image. Up and down will be reversed.
Digital ZOOM Zoom image by 16 steps. (1~16)
PRIVACY This is for privacy zone masking
- ZONE NO : Supports total 15 areas (1~15)
- ZONE OP : Whether to use or not of selected area
- X, Y-POS : Set the X,Y start position of an area
- X, Y-SIZE : Set the width and height of an area
- COLOR(WHT,YEL,CYN,GRN,MAG,RED,BLU,BLK) : Select
color for masking.
- TRANS(0~4) : Set transparency of masking.
SHADING
DET
Before execute the SHADING function, shoot a white
paper in front of the camera, and do SHADING DET. If
not, abnormal video might be output.
SHADING It compensates the difference of light caused by lens.
To use this function, you should run Shading DET
function first at System menu.
DEFOG Images can be corrected on Fog, Dust environment.
- AUTO : Automatically corrects the images.
- MANUAL : can be set to LOW, MIDDLE, HIGH.
COLOR BAR Output Color bar for test purpose (2 types).
If there is no user action, it shows for about 1 minute.
ACE
(ON, OFF)
Adaptive Contrast Enhancement. Enhances image quality by raising the
brightness of dark areas.
DNR
(LOW, MIDDLE, HIGH)
Reduce image noise under low light condition
FRAMERATE
(25Hz, 30Hz)
Power frequency 60Hz(NTSC) : 30Hz(fps) video out
Power frequency 50Hz(PAL) : 25Hz(fps) video out
SYSTEM MODEL Displays model name
CAM ID Max. 8 digits for camera name.
Supports alphanumeric and some special characters
RS485 ID Set ID for RS485
VERSION Displays firmware version
VIDEO Full-Scale(BT 709), Comp-Scale(BT 601) support