User manual

How to upgrade C1080 Series Camera through DVR
1. Check F/W version of DVR and Camera.
- Camera : Over v1.2.x (System  Version info. v1.0.x doesn’t support remote upgrade)
- DVR : Over v3.9.30
- Control Center : Over v2.26.x
2. Connect Com2/Com3(RS-485) port of DVR with RS-485 of C1080 camera.
- GND need to be connected as well as + , - when connect RS-485.
- Use twist pair cable in case the distance between DVR and Camera is far(over 5m).
- Set (Termination) On , in case the distance between DVR and Camera is far (over 5m).
3. If the F/W of DVR is lower than v3.9.30, please update DVR F/W.
4. After upgrade DVR, Please set up Com2 or Com3 port and PTZ as follow.
<Note>
1) In case multi cameras in same Serial port will be upgrade, please assign different ID per each camera.
EX) C1080B x 3ea in same port  RS485 ID is No.1 camera : 1 , No.2 camera : 2 , No.3 camrea : 3.
2) In case multi cameras are updated in same serial port, upgrade will halt when power of camera in same serial line
reboot.
5. Please run “HD_Camera_Upgrader” and follow below steps.
1) Run the HD_Cam_Upgrade then select camera F/W to upgrade.
2) Enter IP address of DVR where to-be upgrade camera is connected then select channel and select upgrade file and click ‘Load’
Com 2 / Com 3
PTZ
Device
PTZ
Enable
Check(√)
Port Dependency : COM2/COM3 RS485
Address : 1~255
Connection
Interface : RS-485
Baudrate : 9600 / 57600
Data Bits : 8bits
Stop Bits : 1bits
Parity : None
PTZ
Device : C1080