Installation Guide
Table Of Contents
- Installation
- Addendum
- Important Safety Notices and Warnings
- Prohibited uses
- CE mark and Radio Equipment Directive for LINK 640
- FCC information for the user
- Specific Absorption Rate (SAR) compliance
- Triman logo
- Operating temperature
- WEEE – e-waste disposal
- How Webfleet Solutions uses your information
- Exposure limits
- Technical Specifications
- Model numbers
- Responsible party in North America
- Emmisions information for Canada
- Warning for Australia
- Notice for New Zealand
- Certification for Australia
- Customer support contact (Australia and New Zealand)
- Customer support contact
- This document
- WEBFLEET Telematics Service Platform
- Accessories not supplied with this device
- Terms and conditions and Limited warranty
- Copyright notices
- Webfleet Solutions Limited Warranty
Attaching the holder using self-tapping screws
You can use two self-tapping screws to fix the holder to your vehicle.
Note: Please refer to the list of what's in the box, to check that the self-tapping screws (3.5 x 16 mm, 1/7
x 5/8 inches) are included in your product package.
1. Choose a flat surface for the LINK 640.
Remember, when the LINK 640 is in the holder, it must not be obstructed by metal objects.
2. Insert the screws into the corresponding holes in the holder.
3. Tighten the screws.
4. Carefully place the LINK 640 in the holder until it clicks into place.
14