Manual

OPERATING THE HANDLE LIGHT
The Weber Grill Out TM Handle Light has a built-in "Tilt Sensor." With the power button
(a) activated, the light will come on when the grill lid is open. The light will turn off when
the lid is closed. For daytime use, deactivate the sensor by pressing power button (a).
PROBLEM
Weber Grill Out'" Handle
Light does not light.
CHECK
Are the batteries old?
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out TM Handle Light activated?
Is the Weber Grill Out TM Handle Light positioned correctly on the handle?
CURE
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
PROBLEM CHECK CURE
Rotisserie burner does not light. Did you hold the burner control knob in and Try to relight burner by holding burner control knob in and continue holding in until
hold in for 20 seconds until after burner 20 seconds after burner has ignited.
ignited?
Did you wait to see the entire ceramic surface When relighting burner by holding burner control knob in, wait to see the entire
become alight before counting 20 seconds? ceramic surface become alight before counting 20 seconds?
Did you repeatedly use the snap ignition until After waiting five minutes for gas to clear, try repeatedly using the snap igniter until
the burner ignited? the burner ignites (refer to "Lighting the Rotisserie Burner").
Does the igniter work (Do you see a spark Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
when you repeatedly use the snap igniter? customer service.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com ®.
PROBLEM CHECK CURE
Side Burner does not light. Is gas supply off? Turn supply on.
Flame is low in "HI" position Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see below).
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.