Manual

MANUAL LIGHTING
A_DANGER
Failure to open lid while igniting the barbecue's burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flame-up
which can cause serious bodily injury or death.
1) Open the lid.
2) Make sure all burner control knobs are turned OFE (Push each burner control
knob down and turn clockwise to ensure they are in the off position.)
3) Turn the gas supply valve on.
4) Insert match holder with lit match into the matchlight hole in the front of the
cooking box.
Z_ WARNING: Do not lean over the open barbecue. Keep your
face and body away from the matchlight hole when lighting
the barbecue.
5) Push Front burner control knob down and turn to START/HI.
6) Check that the burner is lit by looking through the matchlight hole on the front of
the cooking box. You should see a flame.
i/_ WARNING: If the burner does not light, turn the Front i
I
burner control knob to OFF and wait 5 minutes to let the
I
gas clear before you try again.
7) After the FRONT burner is lit you can turn on the other burner or burners.
Note: Always light the FRONT burner first. The other burner or burners ignite from the
FRONT burneL
MAIN BURNER LIGHTING
SPIRIT E/SP-
210 & 310
1
*The grill illustrated may have /
slight differences than the 3
model purchased.
5
TO EXTINGUISH
Push down and turn burner control knob clockwise to the OFF position.Turn gas
supply off at the source,
PROBLEM
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas,
Burner does not light, or flame is low in HI
position.
Experiencing flare-ups:
CHECK
Inspect Spider / Insect Screens for possible
obstructions. (Blockage of holes.)
Is fuel hose bent or kinked?
Does the Left burner light with a match?
Are you preheating barbecue in the prescribed
manner?
Are the cooking grates and Flavorizer e bars heavily
coated with burned-on grease?
/k CAUTION: Do not line the bottom tray with Is the bottom tray "dirty" and not allowing grease to
aluminum foil. flow into catch pan?
Burner flame pattern is erratic. Flame is low when Are burners clean?
burner is on HI. Flames do not run the whole
length of the burner tube.
Inside of lid appears to be "peeling." (Resembles The lid is stainless steel not paint. Itcannot "peel". Clean thoroughly. (See Section "Cleaning".)
paint peeling.) What you are seeing is baked on grease that has
turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.com ®.
CURE
Clean Spider/Insect Screens (See Section "Annual
Maintenance")
Straighten fuel hose.
If you can light the Left burner with a match, then check the
Crossover e ignition system.
All burners on high for 10 to 15 minutes for preheating.
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray
Clean burners. (See Section "Maintenance".)
VT vl vl vl • e
Ik, A, X, A, 1:1:] :k_T_l] _W