Specifications

20 WWW.WEBER.COM
®
TROUBLESHOOTING
GENERAL TROUBLESHOOTING
PROBLEMS SOLUTIONS
Burner does not ignite when you push the
igniterbutton.
Besurethatthereisgasowtotheburnersbyattemptingtomatchlightyourburners.Referto“MAINBURNER
IGNITION—LightingwithaMatch.”Ifmatchlightingissuccessful,theproblemliesintheignitionsystem.Referto
“MAINTAININGTHEELECTRONICCROSSOVER
®
IGNITIONSYSTEM.”
Be sure that wires are correctly inserted into terminals on igniter module. Check that the wires are connected to
terminalsonigniterbuttonunderthecontrolpanel.Referto“IGNITERMODULEWIREGUIDE.”
If a new battery is installed, conrm that battery’s plastic wrapping has been removed. Verify that the battery is in good
conditionandhasbeeninstalledcorrectly.Referto“MAINTAININGTHEELECTRONICCROSSOVER
®
IGNITION
SYSTEM.”
Burners do not ignite.
Burners have a small ickering ame when burner
control knobs are in the high (
) position.
Grill temperature only reaches 250° to 300° F in
the high (
) position.
The excess ow safety device, which is part of the grill-to-cylinder connection, may have been activated. To reset the
excessowsafetydevice,referto“MAINBURNERIGNITION.”
m DANGER: When the “excess gas ow control” feature is activated, a small amount of gas is still owing to
the burners. After turning off the LP cylinder valve and burner control knobs, wait at least ve minutes for the
gas to clear before attempting to light the grill. Failure to do so may result in an explosive are-up, which can
cause serious bodily injury or death.
Burner does not ignite, or ame is low in
high (
) position.
LP fuel could be low or empty. Rell LP cylinder.
Fuel hose could be bent or kinked. Straighten fuel hose.
Burner ame pattern is erratic.
Flame is low when burner is on high (
) position.
Flames do not run the whole length of the
burnertube.
Cleanburnerportsthatrundowntheentirelengthofburnertube.Referto“ANNUALMAINTENANCE.”
Burners burn with a yellow or orange ame, in
conjunction with the smell of gas.
Inspect spider/insect screens for possible obstructions. (Blockage of holes.) Clean spider/insect screens.
Referto“ANNUALMAINTENANCE.”
Experiencing are-ups.
m CAUTION: Do not line the slide-out
grease tray with aluminum foil.
Grill must be preheated with all burners on high for 10 to 15 minutes.
Clean the cooking grates and Flavorizer
®
barsthoroughlytoremovegrease.Referto“CLEANINGTHEINSIDEOF
THEGRILL.”
The slide-out grease tray may be dirty and is not allowing grease to ow into catch pan. Clean slide-out grease tray.
Inside of lid appears to be “peeling.”
(Resembles paint peeling.)
Theinsideofthelidisporcelainenamelorstainlesssteel.Itisnotpainted.Itcannot“peel.”Whatyouareseeingis
baked-on grease that has turned to carbon and is aking off. THIS IS NOT A DEFECT. Clean thoroughly. Refer to
“CLEANINGTHEINSIDEOFTHEGRILL.”
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.