Specifications

18 WWW.WEBER.COM
®
Summary lighting instructions are inside
the cabinet door.
MAIN BURNER IGNITION & USAGE
2
5
1
3
4
METHODS OF BURNER
IGNITION
There are two ways to ignite
burner 1. The first is by using
the electronic Crossover
®
ignition system built into your
grill. The second is with a
match.
Next are the steps for igniting
your grill using the electronic
Crossover
®
ignition system.
On the following page are
steps for igniting your grill
with a match.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your grill with the electronic
Crossover
®
ignition system.
Do not confuse this plastic
with the battery label.
MAIN BURNER IGNITION
Electronic Crossover
®
Ignition System
The electronic Crossover
®
ignition system ignites burner
1 with a spark from the igniter electrode inside the Gas
Catcher™ ignition chamber. You generate the energy for
the spark by pushing the igniter button. You will hear the
igniter clicking. Burner(s) 2 (and 3) can be lit after burner
1 is lit.
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting
the grill’s burners, or not waiting ve
minutes to allow the gas to clear if the
grill does not light, may result in an
explosive are-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned
off(2). Check by pushing control knobs in and turning
them clockwise until they stop.
m WARNING: The burner control knobs
must be in the off ( ) position before
you turn on the LP cylinder valve. If
they are not in the off ( ) position
when you turn on the LP cylinder
valve, the “excess gas ow control”
feature will activate, limiting the ow of
gas from the LP cylinder. If this should
occur, turn off the LP cylinder valve
and burner control knobs. Start over.
m DANGER
When the “excess gas ow control”
feature is activated, a small amount of gas
is still owing to the burners. After turning
off the LP cylinder valve and burner
control knobs, wait at least ve minutes
for the gas to clear before attempting to
light the grill. Failure to do so may result
in an explosive are-up, which can cause
serious bodily injury or death.
C) Turn the LP cylinder on by SLOWLY turning the
cylinder valve counterclockwise (3).
D) Push burner 1 control knob in and turn it
counterclockwise to start/high ( ) position (4).
IMPORTANT: Always ignite burner 1 rst. The other
burner(s) ignite from burner 1.
E) Push and hold in the igniter button (5). You will hear
the igniter clicking.
F) Check that burner 1 is lit by looking through the
cooking grates. You should see a ame.
m WARNING: Do not lean over the open
grill.
m WARNING: If burner 1 fails to ignite
within ve seconds, stop, turn the
burner control knob to off and wait
ve minutes to allow the gas to clear
before you try again or light with a
match.
G) After burner 1 is lit, you can turn on burner 2 (and
burner 3).
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.