Specifications

70 • 4. Maintenance and Calibration TC3500 Operation Instructions
4.2 Maintenance Replacement Parts
QTY NAME NUMBER
1 Safety Goggles 179-15-2
1 Brush RP6-1506
1 Mounting Paste RP6-5749995
1 Steel Jaw Cover (Set Of 4) RP6-2035
1 Mount/Demount Head RP6-0343
1 Straight Bead Lever RP6-0322
1 “HM” Bead Lever RP6-2440
1 Bead Lever Protector Sleeve RP6-0326
1 Rubber Bonded External Clamping
Jaw
RP6-3656
4.3 Calibrating and Adjusting the Position of the Column
Check the column position as follows:
Clamp a 14 or 15 inch rim without tire.
Position the mount/demount head against the outer edge of the rim.
Verify that the left-hand side of the mount/demount head has a clearance
of 1/8 inch from the rim edge while rotating the clamping device. The
right side of the mount/demount head must contact the edge of the rim.
Adjust the column position as follows:
Remove bolt securing rear panel to base. Set rear panel and bolt aside.
Loosen the four mounting bolts securing column to the base.
Clamp a 14 or 15 inch rim without tire.
Position the mount/demount head against the outer edge of the rim.
Turn the column so that the left side of the mount/demount head has a
clearance of 1/8 inch from the rim edge, while rotating the clamping device. The
right side of the mount/demount head must contact the edge of the rim.
Tighten and torque four mounting bolts securing column to the base to 45 ft-lbs.
Re-install rear panel and secure to base with bolt previously removed.