Specifications

TC3500 Operation Instructions 3. Advanced Procedures • 31
Remove the block and shaft from the rim by pushing out to relax from rim.
Retract the upper roller.
Unlock the bead roller assembly by pulling up on the fixation knob and swing the
bead roller assembly away to the resting position.
Mounting Low Profile Tires on Rounded Edged Rims
On certain types of alloy rims with round flanges, there is a potential to rub the
surface of weak coated rims. To eliminate this potential, the following procedure
should be used:
NOTE: Only use this procedure on rims with rounded edges.
Lubricate tire bead and rim flange area.
Adjust articulating arm back to the #4 position.
Push upper roller down against tire to ensure the mounting head is secured by the
upper roller. This will prevent the mounting head from popping up when the tire is
fully mounted.