Specifications

TC3500 Operation Instructions 3. Advanced Procedures • 29
Position the fixed block of the bead depressor between the rim and the bead of the
tire that was previously positioned below the rim lip.
Swing the bead roller assembly in toward the unit to the working position (against the
stop).
Lock the bead roller assembly into the working position by pushing down on the
fixation knob.
Set the rim diameter approximately 2 inches larger than the actual rim diameter by
moving the command unit away from or toward the unit.
Lock the upper roller onto the sidewall of the tire.
Position the bead of the tire under the right side of the mount head.
Rotate the wheel clockwise and position each of the attached blocks of the bead
depressor onto the rim as shown below. Each block should be positioned as far away
from the next block as the cord will allow.