Specifications

TC3500 Operation Instructions 3. Advanced Procedures • 25
Push bottom roller up again to fully bring tire bead over head.
Rotate the wheel counterclockwise approximately 1/2 inch to unfurl tire bead onto
the bead lever.
Slide the bead lever tool out from between the mount/demount head and the bead of
the tire. The bead of the tire must remain over the right-hand end of the head.
Rotate wheel clockwise until the entire bead is lifted from the rim. Retract the lower
roller to the resting position.
Remove the Bead Depressor “Tail” from the rim. Refer to “Removal of Bead
Depressor Tail,” page 30.
Using Force Multiplier, RP6-8832
NOTE: When demounting the tire, the polymer head should be fully
seated against the wheel or it may become over stressed
and prematurely fail. Fully seating the polymer head against
the wheel can be accomplished by using the Force Multiplier
to seat the head against the wheel.
NO GAP
GAP
CORRECT (FULLY SEATED) MOUNT/DEMOUNT HEAD INCORRECT (NOT FULLY SEATED) MOUNT/DEMOUNT HEAD