Specifications

TC3500 Operation Instructions 3. Advanced Procedures • 23
Lock the bead roller fixation knob.
Rotate the wheel clockwise until the valve stem is at the 1 o'clock position.
Lubricate and push the bead depressor post through the center hole of the rim until it
has been inserted into the spring centering system.
HINT: If the post will not insert into the center hole, the wheel
support is depressed too far down. Release the clamping
jaws and reposition the arms to allow for less compression
of the support and try again.
Push the sidewall down with upper roller to allow the insertion of the block on the
arm.
Slide the horizontal arm of the tail so the fixed block is positioned into the rim flange
as shown below.