Specifications

18 • 2. Basic Procedures TC3500 Operation Instructions
Step down completely on the air inflation pedal to release a high-pressure air blast
through nozzles on the air inflation ring to assist in seating the beads of the tire.
Step down partially on the air inflation pedal to inflate tire and seat the beads.
WARNING: Do not exceed 40 PSI when seating the beads of a tire.
After beads have been seated, disconnect inflation hose and reinstall valve stem
core previously removed. Then connect inflation hose and inflate tire to the required
pressure.
If the preset adjustable inflator is used, step down partially on the pedal until inflator
cycling stops. The tire will be inflated to the preset inflation pressure. Refer to “Inflator
and Pressure Limiter.”
If tire is over inflated, air may be removed from the tire by pressing the brass manual
air release button located below the air pressure gauge.
Disconnect inflator hose from valve stem.
2.7 Removal of Wheel from Tire Changer
Remove wheel-securing device, if installed.
For rims clamped on inside, lift the clamping pedal to release the rim from the
clamping device.
For rims clamped on outside, step down on the clamping pedal to release the rim
from the clamping device.