owners guide

21
TROUBLESHOOTING
K
G
H
I
J
weber.com
8. Remove the auger/motor assembly by first removing the two screws
from the bracket. Carefully slide and twist the auger/motor assembly out
and away from the grill (G), (H).
NOTE: Visually note the orientation of the motor when attached to the auger tube.
9. Remove the auger and motor from the auger tube by first removing the
four fastening screws, then pull and twist the auger and motor out from
the auger tube (I).
10. Clean the auger tube and auger/motor to remove any pellets and debris
that may have been jamming the auger.
11. Before reinstalling the auger and motor back into the auger tube, verify
that the shear pin is still intact (J). Both sides of the pin should be fully
engaged and visible. The auger should not pull away from the motor.
If the shear pin is broken, it should be replaced before reassembling.
Contact a WEBER Customer Service Representative in your area using
the contact information on our website for a replacement.
12. Reinstall the auger/motor by sliding the auger through the auger tube
and fastening it with four screws (K).
CAUTION: Make sure the auger/motor is in the correct orientation when
reinstalling into the auger tube. See illustration (K).