Installation guide

103666_EBH_Rev1.0_080215
MPE 750 Turbo Marine
Closed Loop
Installation Guide
Page 23
7 First engine run and brake in
• Prime the fuel system: Activate the fuel pump by turning on the key switch (not in start position).
• Connect the fl ush system as described in section 4.2
• Start engine. Do not accelerate. The engine may only be operated at idle speed for a maximum of 30
seconds without sea water
• Ensure the water supply within 30 seconds
• Check if the water out of the outer cooling loop is leaving the boat.
• Check if the injected water is leaving the exhaust
• Stop water supply
• Check oil level as described on the hang tang on the oil tank
• Check coolant level (1) of the inner cooling loop
1
ATTENTION
Coolant level below the MIN marking can cause damage
to the engine due to overheating.
Coolant level below the MAX marking should be avoided
to prevent environmental damage