Installation guide

103666_EBH_Rev1.0_080215
MPE 750 Turbo Marine
Closed Loop
Installation Guide
Page 18
6.1 Electric
The engine can give out following output / informations:
• MIL (Malfunktion Indicator Light): Will be activated when engine performance is limited
• Engine overtemperature lamp: Is activated when engine temperature exceed the limit
• Oil pressure lamp
• Engine speed signal
• Engine up to 98 kW: 2 pulses/rev
• Engine 105 kW: 6 pulses/rev
The wireing for the oil pressure lamp is not included in the engine wire
harness and has to be implemented in the boat harness.
The EMS / engine package includes sensors and control strategies for:
• Raw water supply: temperature sensor in exhaust manifold
• Altitude: air pressure sensor
• Temperature: air and coolant temperature
• RPM: Crank sensor
• Start: Phase sensor for cylinder 1 detection
• Turbo System: pressure sensor for boost control
• Oil System: oil pressure switch to warning lamp
• Emissions / Performance: closed loop lamda control
Specifi cation
Malfunktion Indicator Light (MIL) max. 10 Watt
engine overtemperature lamp max. 10 Watt
oil pressure lamp max. 10 Watt
engine speed signal
Engine up to 98 kW: 2 pulses/rev
Engine 105 kW: 6 pulses/rev
battery capacity 12 V / 10 Ah
starter solenoid 600 A steady state
internal generator with regulator Idle: 150 Watt > 3000rpm: Watt max. 340 Watt