User manual

USER MANUAL OF WEBEE WIRELESS N ROUTER Version:1.1
Firmware Type 2
P/N: 60291092
45
Continuous connection type means to setup the connection
through PPPoE protocol whenever this WLAN Broadband
Router is powered on.
Connect on Demand connection type means to setup the
connection through PPPoE protocol whenever you send the
data packets out through the WAN interface; there are a
watchdog implemented to close the PPPoE connection while
there are no data sent out longer than the idle time set.
Manual connection type means to setup the connection
through the PPPoE protocol by clicking the Connect button
manually, and clicking the Disconnect button manually.
Idle Time If you select the PPPoE and Connect on Demand
connection type, fill in the idle time for auto-disconnect
function. Value can be between 1 and 1000 minutes.
MTU Size Fill in the mtu size of MTU Size. The default value is 1452.
Refer to 4.23 What is Maximum Transmission Unit (MTU)
Size?
Attain DNS Automatically Click to select getting DNS address for PPPoE support.
Please select Set DNS Manually if the PPPoE support is
selected.
Set DNS Manually Click to select getting DNS address for Static IP support.
DNS 1 Fill in the IP address of Domain Name Server 1.
DNS 2 Fill in the IP address of Domain Name Server 2.
DNS 3 Fill in the IP address of Domain Name Server 3.
Clone MAC Address Fill in the MAC address that is the MAC address to be cloned.
Refer to 4.24 What is Clone MAC Address?
Enable uPNP Click the checkbox to enable uPNP function.
Refer to 4.22 What is Universal Plug and Play (uPNP)?
Enable IGMP Proxy Click the checkbox to enable IGMP Proxy.
Enable Ping Access on WAN Click the checkbox to enable WAN ICMP response.
Enable Web Server Access on WAN Click the checkbox to enable web configuration from WAN
side.
Enable FTP Server Access on WAN Click the checkbox to enable FTP Server Access on WAN
Enable IPsec pass through on VPN
connection
Click the checkbox to enable IPSec packet pass through
Enable PPTP pass through on VPN
connection
Click the checkbox to enable PPTP packet pass through
Enable L2TP pass through on VPN
connection
Click the checkbox to enable L2TP packet pass through
Apply Changes Click the Apply Changes button to complete the new
configuration setting.
Reset Click the Reset button to abort change and recover the
previous configuration setting.