User manual

USER MANUAL OF WEBEE WIRELESS N ROUTER Version:1.1

Firmware Type 2

P/N: 60291092

Beacon Interval Set the Beacon Interval, value can be written between 20 and 1024

ms.

Refer to 4.12 What is Beacon Interval?

Preamble Type Click to select the Long Preamble or Short Preamble support on

the wireless data packet transmission.

Refer to 4.13 What is Preamble Type?

IAPP Click to enable or disable the IAPP function.

Refer to 4.20 What is Inter-Access Point Protocol(IAPP)?

Protection Protect 802.11n user priority.

Aggregation Click to enable or disable the Aggregation function.

Refer to 4.33 What is Aggregation?

Short GI Click to enable or disable the short Guard Intervals function.

Refer to 4.34 What is Guard Intervals (GI)?

RF Output Power To adjust transmission power level.

Apply Changes Click the Apply Changes button to complete the new configuration

setting.

Reset Click the Reset button to abort change and recover the previous

configuration setting.

4.3.6 Wireless - Security Setup

This page allows you setup the wireless security. Turn on WEP, WPA, WPA2 by using

encryption keys could prevent any unauthorized access to your wireless network

Item Description

Select SSID Select the SSID from multiple APs.

Encryption Select the encryption supported over wireless access. The

encryption method can be None, WEP, WPA, WPA2 or WPA-

Mixed

Refer to 4.9 What is WEP?

4.15 What is Wi-Fi Protected Access (WPA)?