User manual

USER MANUAL OF WEBEE WIRELESS N ROUTER Version:1.1

Firmware Type 2

P/N: 60291092

4. SOFTWARE CONFIGURATION

There are web based management and configuration functions allowing you to have the

job done easily.

The Webee Router is delivered with the following factory default parameters on the

Ethernet LAN interfaces.

Default IP Address: 192.168.1.254

Default IP subnet mask: 255.255.255.0

WEB login User Name: <blank>

WEB login Password: <blank>

4.1. PREPARE YOUR PC TO CONFIGURE THE ROUTER

For OS of Microsoft Windows XP:

1. Click the Start button and select Settings, then click Control Panel. The

Control Panel window will appear.

2. Move mouse and double-click the right button on Network and Dial-up

Connections icon. Move mouse and double-click the Local Area

Connection icon. The Local Area Connection window will appear. Click

Properties button in the Local Area Connection window.

3. Check the installed list of Network Components. If TCP/IP is not installed,

click the Add button to install it; otherwise go to step 6.

4. Select Protocol in the Network Component Type dialog box and click Add

button.

5. Select TCP/IP in Microsoft of Select Network Protocol dialog box then click

OK button to install the TCP/IP protocol, it may need the Microsoft Windows

CD to complete the installation. Close and go back to Network dialog box

after the TCP/IP installation

6. Select TCP/IP and click the properties button on the Network dialog box.

7. Select Specify an IP address and type in values as following example.

9 IP Address: 192.168.1.1, any IP address within 192.168.1.1 to

192.168.1.253 is good to connect the Wireless LAN Access Point.

9 IP Subnet Mask: 255.255.255.0

8. Click OK to complete the IP parameters setting.

For OS of Microsoft Windows Vista:

1 Click the Start button and select Settings, then click Control Panel. The

Control Panel window will appear.

2 Move mouse and double-click the right button on Network Connections

item. The Network Connections window will appear. Double click Local

Area Connection icon, then User Account Control window will appear.

Right click the Continue button to set properties.

3 In the Local Area Connection Properties window, select Networking tab,

move mouse and click Internet Protocol Version 4 (TCP/IPv4), then click