Owner's manual

WebDT Mobile Tablet Barcode Scanner Operation Guide
HyperTerminal
www.dtresearch.com
HyperTerminal
HyperTerminal
The HyperTerminal can be used to connect the Barcode Scanner and MSR.
1. Run Start l All Programs l Accessories l Communicaons l HyperTerminal to run the
HyperTerminal.
2. Input a connecon name in “Connecon Descripon” window.
3. Choose the connecon port (please refer to the parameters table
of each module), then click OK.
4. Change the port Properes (please refer to the parameters table
of each module), then click Apply to complete the sengs.
5. If the sengs are all correct, HyperTerminal will be connected to
the module. Scan a barcode or swipe a card, the captured data
will display in the HyperTerminal window.
6. Verify the captured data.
WebDT 390/ 390i OPERATION GUIDE