User guide

DT312
ENGLISH
2
Buon Funcons
BUTTON ACTION
Programmable
Programmable, launch so (on-screen) keyboard (default)
Launch SAS (Secure Aenon Sequence)
Generate Ctrl+Alt+Del keys to invoke the security windows defined under Windows XP
Programmable,
Change display orientaon (portrait/ landscape) (default)
Programmable, system ulity menu (default)
Programmable,
As scanner trigger when equipped with the scanner module
Push/release typic
ally enters Standby mode, or Push/release exits Standby mode or
restarts device (soware dependent)
Push and hold (over 4 seconds) invokes hardware shutdown
Input/ Output Ports
DC Power Input
Headphone Jack
Microphone Jack
USB Ports (2)
The DT312
For locking the MSR module
Baery/Power LED
Wireless LED
Stylus
Calibraon
Internal Baery Switch
(back panel)
1
1
2
2
3
3
4
4
5
5
6
6
9
B
D
8
C
A
A
B
C
D
8
9
7
7
Buon Management
Wireless Network Sengs
Baery and Power Meter
7
ENGLISH
Peripherals Support
Through its USB ports, the DT312 supports a wide range of USB-based peripherals.
These peripherals are applicable for soware installaon, applicaons storage, data
storage, and system soware recovery and updates. The DT312 is also compable with
custom mountable cradle opons. These securable and mountable cradles provide an
interface to VESA mounts and arms, and to ports
that may include USB, Ethernet, and
pass-through power.
Remote Management
Depending on soware configuraon, the DT312 can be centrally managed for asset
monitoring and for soware control. Please consult your device provider.
Federal Communicaon Commission Interference
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rule
s. These limits are designed to provide
reasonable protecon against harmful interference in a residenal installaon. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not occur in a
parcular installao
n. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separaon between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different
from that to which the •
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.•
FCC Cauon: Any changes or modificaons not expressly approved by the party
responsible for compliance could void the user
’
s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions: (1) This device may n
ot cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operaon.
This device and its antenna(s) must not be co-located or operang in conjuncon with
any other antenna or transmier.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003
du Canada.