User Manual

WebDT Mobile Tablet Barcode Scanner Operation Guide
Mobile POS Tablet
Magnec Stripe Reader
OPERATION GUIDE
www.dtresearch.com
Installaon
The Magnec Stripe Reader (MSR) is preinstalled as an opon for
WebDT 312/ 362.
To Connect Magnec Stripe Reader Module
To connect the Magnec Stripe Reader, you can use the
WebDT Keyboard Wedge. Tap on the icon in the
task bar, a menu is displayed as shown in the picture
below. Choose Connect MSR.
To Congure MSR
For a magnec stripe card, the raw data in each data track may contain start and end sennel
characters. To remove those characters, you can select the Congure MSR command to parse input
raw data and lter out the start and end sennel characters on each track.
Click Cong MSR in the WebDT Keyboard Wedge menu, and the MSR Applicaon
1.
Conguraon window will be displayed.
Choose Enable in the Parse Data secon.
2.
Choose data you want to parse at the start or
end of each track.
For Example:
Check Track 1
In Start Sennel Character, select %
•
In End Sennel Character, select ?•
Click OK to complete the sengs3.