User Manual

WebDT Mobile Tablet Barcode Scanner Operation Guide
Mobile POS Tablet
Barcode Scanner
Installaon
The Barcode Scanner is preinstalled as an opon for WebDT 312/ 362.
Buon Management
To assign Scanner Trigger buon, follow the procedures below.
1. Start Buon Manager by clicking on in the system tray.
2. Click on to go to the second screen of Buon Manager.
3. Select an available unused buon marked with the icon .
4. Click on the icon to assign the Scanner Trigger to the
unused buon.
5. Click OK to apply conguraon sengs and close the
window.
Scanner Conguraon
To Add/Remove Symbologies, follow the procedures below.
1. Click Start | All Programs | DT Research | Buon Manager | ScannerCong.
2. Select COM3 and click Connect buon.
3. Add Symbology with
buon and Remove Symbology with buon.
4. Select the Beep aer scanning barcode checkbox to enable beep sound aer
scanning bar code or deselect it to disable the beep sound.
5. Click OK to apply the conguraon sengs and close the window.
To Connect Barcode Scanner Module
To connect the Barcode Scanner, you can use the WebDT Keyboard
Wedge to connect. Tap on the icon in the task bar, a menu
displayed as shown in the picture below. Select Connect Scanner.
To Test Barcode Scanner Module
Click 1. Start | All Programs | Accessories | Notepad to run the Notepad
Scan one of the several supported barcode Symbology. The output will appear in the Notepad
2.
screen.
Verify the captured data.
3.
OPERATION GUIDE
www.dtresearch.com

Summary of content (6 pages)