Unit installation

6
Mercedes-Benz E-Class BR 211 / CLS BR 219
Loosen the bumper on the side facing the
wheel well:
Loosen the screws, move the clamping bar to
the front and remove it.
1 Clamping bar
2 Bolt
3 Coolant hose to the heater unit (will be
added Later, not yet present during
disassembly)
Tips and
Tricks
To route wiring harnesses and wires through
grommets, cable ducts or tight areas, we
recommend using the mecanyl fuel line. This,
for example, is pushed through a cable duct
until the desired point is reached, the wiring
harness is fastened with insulation tape and
pulled behind.
Tips and
Tricks
Preparing the wiring harness
Remove the wiring harness twine between
the connection of the fuel pump plug and the
unwrapped section.
1 Beginning of the wrapped section
2 Disconnecting the fuel pump connector
3 Fuel pump connector (blue)
Removing
the
wiring
harness
twine
2
2
1
3
1
3
2
3