Unit installation

16
Mercedes-Benz E-Class BR 211 / CLS BR 219
Place the moulded coolant hose in the gap
in the windshield fluid container and
then along the wiring harnesses under
the container shackle.
1 Windshield fluid container shackle
B Moulded coolant hose
Routing
the coolant
hose
Slide the long remnant of the braided hose
protection on hose C l=800 mm.
On one side, slide on the red rubber insulator.
On both sides, insert the coolant hose
couplers and fasten with clamps.
1 Spring band clamps Ø25 mm [2x]
2 Braided hose protection
3 Rubber insulator, red
4 Coolant hose coupler 15x18 [2x]
Coolant
hose
preassem-
bly
Connect the preassembled coolant hose to
the moulded hose and fasten with
clamp.
Remove the filling from the conduit.
Move the coolant hose to the front through
the guide.
Clip on the conduit cover.
1 Conduit cover
B Moulded hose
2 Spring band clamp Ø22 mm
C Coolant hose
Place
coolant
hose in
guide
Route coolant hose under the cross rail
according to Figure 39.
(Figure shows the CLS, always check
for access to the headlight!)
1 Coolant hose C
Installing
coolant
hose
36
B
1
37
1 432
38
C
B
1
2
39
1