Installation Manual

Webasto Air Top Installation Guide – AT2000STC
16
Air Top 2000STC Installation Guide 2018 | Webasto Thermo & Comfort Australia Pty Ltd.
8 Basic Layout of Complete Installation
9 Reset Procedures
Rotary Control
When the controller starts to flash, disconnect the power supply to the heater by:
1) Whilst the controller is in the on position & code flashing, remove the fuse (15A) or disconnect power to the
heater
2) Turn the dial switch to off
3) Wait for a few minutes
4) Re-install the fuse
5) Restart the heater
COMPONENT
DESCRIPTION
COMPONENT
DESCRIPTION
1
CONTROLLER
8
FUEL STANDPIPE
2
INTERFACE VEHICLE HARNESS
9
FUEL TANK
3
HEATER FUSES – F1 (15A) &
F2 (10A) {Fig. 13 Pg 9}
10
FUEL LINE
4
HOT AIR OUTLET
11
EXHAUST PIPE
5
HOT AIR OUTLET DUCT
12
COMBUSTION AIR INTAKE PIPE
6
FUEL PUMP
13
RETURN (HEATING) AIR INTAKE
GRILL
7
FUEL FILTER
Fig 29 – Basic Complete Installation Layout