Repair manual
Component Replacement Air-handler Assembly
www.webasto.us 45 Webasto Product N.A., Inc.
™
3. Turn cover over and remove control knobs. Knobs
are held on by a small set-screw.
4. Remove the two panel nuts and washers from rotary
switch shafts.
Figure 46. Control unit removal - Step 2
5. Control unit is now free to pull away from back-side
of cover.
Figure 47. Control unit removal - Step 3
Installation
Before handling the new control unit,
discharge any possible static electrical charge
from your body by touching a grounded metal
surface.
1. Reassembly in reverse order of removal.
10.4 Fan Replacement
Removal
1. Follow directions in Sec. 10.2 "Air-handler Cover
Removal" on page 44.
2. Carefully disconnect the 2-pin fan wiring plug of the
defective fan from control unit receptacle.
3. Remove the four screws holding the fan to the cover.
4. Remove fan from fan recess of cover.
Installation
1. Reassembly in reverse order of removal.
Figure 48. Fan replacement
O
I
AIR CONDITIONING