Installation Instructions

Test software access to different test modes: SecureCRT
Testing item, Frequencies, Transmit Power, Modulation Type can be set.
WIFI:
./wifi_setup1.sh
11B 2412
./wl_24G_11B_TX.sh 1 1 （first 1 is data rate, 1，Second 1 is channel 1）
wl down （Stop transmit）
11G 2442
./wl_24G_11G_TX.sh 6 7
wl down
11N20 2472
./wl_24G_11N_HT20_TX.sh 0 13
wl down
BLE:
ble
./ble_setup1.sh
2402
./BLE_TX_test.sh 00 25 00
./BLE_TX_test.sh
2440
./BLE_TX_test.sh 13 25 00
2480
./BLE_TX_test.sh 27 25 00
⚫ FCC other Parts, Part 15B Compliance Requirements for Host product manufacturer
This modular transmitter is only FCC authorized for the specific rule parts listed on our grant, host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification.
Host manufacturer in any case shall ensure host product which is installed and operating with the module is in
compliant with Part 15B requirements.
Please note that For a Class B or Class A digital device or peripheral, the instructions furnished the user manual of
the end-user product shall include statement set out in §15.105 Information to the user or such similar statement
and place it in a prominent location in the text of host product manual. Original texts as following:
For Class B
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be