User`s guide

Web Mountain Technologies Page 73
Now, you’re done and have successfully programmed your RUC with the
updated firmware. Merely click on the “X” in the right hand corner to shut down
the application.
Depending on the version you are upgrading from and to, you may need to do a
factory reset. If you have backed up your RUC settings prior to performing the
firmware upgrade, you will be able to use the Backup/Restore button to restore
all these settings.
If a factory reset is recommended, hold both S1 and S2 down, then after a few
seconds release S1. One of the LEDs will flash quickly. After a few seconds,
both LEDs will flash 3 times. After a few more seconds, both LEDs will flash 6
times. Now, you can release S2. The process is complete. At this point, you
can restore any settings that you had before.
NOTE: If you are updating a unit that was previously at V57 or higher, it may
not be necessary to do a factory reset on the unit. – the unit will retain its
settings properly.