User`s guide

Web Mountain Technologies Page 64
Select a COM port you want to use. Make sure it is high enough that it doesn’t
interfere with one of the hardware COM ports on your PC. Notice that we used
COM10.
Enter in the IP address of the RUC device (the local address on your LAN). You
can find this from the Networking Configuration webpage on your RUC.
Then, you need the port # that the RUC will be using to convert serial traffic
onto the TCPIP network. By default, the RUC is set to 9761. You can change
this, but in most cases, 9761 will work for you.
Now, click on the CREATE COM button. You will see this:
Now, open Upstart. Upstart will probably give you an error message that it can’t
communicate with the PIM. Click out of these pop ups and get to the main
screen of Upstart. Click on Tools, UPB Interface Device, Select. You will see this
screen. In the Interface box select Powerline Interface Module, then select the
COM port that matches the COM port you selected above in HW-VSP. Then,
click on CONNECT.