User`s guide

Web Mountain Technologies Page 60
Chapter 4
Remote Upstart
This chapter provides information about how to use your RUC unit with Upstart
remotely over your LAN or over the Internet. It includes:
 How to get the necessary components
 Configure the RUC and Upstart to run over your LAN
CAUTION: It should be noted that UPStart operation over a network will naturally be
slower than with a hard-wired PIM. If you are having problems, a retry or two of the test
you are trying to run should get you accurate results. It is strongly encouraged that the
user configure Upstart slightly differently than normal - select “Ask if verify should be
performed” or “Never perform verify at startup” on the Tools | Options | Upstart File tab
rather than “Always perform verify at startup”. It is also strongly suggested that the user
do individual device verifies rather than network verifies whenever possible. Smaller
chunks of testing will perform better than larger chunks, especially in the situation where
there is some congestion on the network.
Also, to shut off Idle Reports, use the RUC command code under Tools | Options | Extra
Features.
NOTE:
If you have a Remote Upstart session running on COMx (1 or 2), you cannot
simultaneously run another application to that port. For example, if you have
Remote Upstart running on socket port 9761 to COM1, you cannot run the iOS
app, UPB Remote, on your iPhone or iPad using these same sockets and ports.
UPB Remote will not run and Remote Upstart will gradually deteriorate and
become unusable.