User`s guide

Web Mountain Technologies Page 32
able to enter raw hex values. To enter a raw hex value, put a “^” in front of it. In this case, the
entry is telling the RUC to look for a hex 0x02. The ^00 hex null character is a special string –
if it is the last character in a string, it tells the RUC to not look for a Carriage Return after the
string entered into the text box. So, in this case, the RUC will look for a hex 0x02, followed by
the ASCII characters, but it won’t look for a carriage return after the serial string.
To setup an X10 command as the trigger event (uses the Smarthome 2413S interface unit),
select X10 from the dropdown box. Then, select your House Code, Unit code, and command
type from the dropdowns or you can enter in a serial string in the X10 command text box:
Different Protocols being Sent from the Trigger
Now, for the Send commands. Once you have setup your Receive triggers, then the user can
determine what action will occur for that trigger. The following is the list of all the actions that
can occur:
 Send an Email
 Send an ESI RQ command
 Send a UPB Direct Command
 Send a UPB Link Command
 Send a Zwave Command
 Send a Raw Command
 Change the RUC’s operating Mode to Home
 Change the RUC’s operating Mode to Vacation
 Send an Insteon command
 Send an X10 command
 Send a POST / PUT command
Notice that many of the Send Commands allow you to add a delay – the amount of time to
delay before sending the command after the Receive trigger is received. The maximum amount
of delay time available is 17 hours, 59 minutes, and 59 seconds.
To Send an Email, the user must enter the To address, enter a subject line, and enter the body
of the email. All three of these fields are limited to 40 characters each. If you try to enter more
characters, the entry will be truncated and only the first 40 characters will be submitted. The
image below shows an Email entry for a Send Command: