Use and Care Manual
AFTER INSTALLATION CARE
After your cabinets have been installed, wipe down all exteriors with a damp cloth to remove dust.
Clean Up: Wash WeatherStrong with water and a soft cloth or sponge. A mild dishwashing liquid can be used
if needed. For tougher to clean spots, wash with Simply Green All-Purpose Household Cleaner. A soft bristle
brush may be used if needed.
EVERYDAY CARE
Salt Water Environments: Oceanfront environments with salt air and sea spray will require regular maintenance
and cleaning to prevent rust from forming on the handles, hinges and drawer runners. Clean stainless steel
surfaces several times a month to keep the chemical reaction, from the salt, from gaining a foothold on the
hardware. With regular cleaning, your cabinets will look like new for many years. To achieve maximum
corrosion and stain resistance, the surface of the stainless steel must be kept clean.
NEVER use abrasive cleaners, scouring pads or powdered cleansers.
HARDWARE CARE
Use mild soap and warm water to clean door, drawer knobs and pulls. Thoroughly dry hardware surfaces after
cleaning. DO NOT use silver or brass polish.
GRILL & SIDE BURNER CABINET MODIFICATIONS
Grill and side burner cabinets are manufactured with two full upper face plates that will need to be eld
modied to accept the respective insulated jacket used with the gas grill or side burner.
The second matching panel will be shipped loose for ease of modication and installation. It can be attached
with stainless steel screws or a suitable construction grade adhesive. Under no circumstance should a grill or
side burner be installed without the appropriate heat liner specied by the manufacturer of the appliance.
HEAT APPLIANCES
Free‑standing grills with adequate space from direct heat are recommended or grills with insulated jacket
specied by the grill manufacturer can be installed in WeatherStrong cabinets.
Insulated jackets are required for heat admitting appliances being installed in WeatherStrong
LIGHT EXPOSURE
Cabinet sides and backs that will be exposed to direct sunlight and other weather elements MUST be covered
by a matching end panel in coordinating High Density Polyethylene (HDPE). Failure to install these protective
panels will void the cabinet warranty.