Specification

49
48
888-745-0004 · weatherstrong.com · 888-745-0004 · weatherstrong.com ·
Prior to installation you will nd it easier to handle the
cabinet with the doors and drawers removed.
Hinges can be removed from the hinge plate by simply
pressing in the release button on the end of the hinge,
and pulling away from the cabinet. They are re-attached
by hooking the hinge to the plate and snapping the
pressure release into place.
ANCHORING TO CONCRETE BLOCK WALLS
1. Each Wall Cabinet requires 4 wall anchors (2 top, 2
bottom)
2. Screws should be placed in each corner
approximately 2” from the end panels.
3. Pre-drill the pilot holes before you place the cabinet
against the wall, with a standard 3/16” drill bit.
4. Then put the cabinet in place. In each corner use the
3/16” Tapcon bit through the pilot holes to create
ANCHORING TO CONCRETE BLOCK WALLS
Pull the drawer out until it stops. Each drawer runner
has a small plastic release tab. One tab will point up
and the other will point down. Holding the drawer box
on each side, push the tabs in the opposite direction
from which they’re pointing and carefully pull the
drawer box out. Carefully push the runners back into
the cabinet.
starter holes into the concrete block, for the
Tapcon anchors.
5. Remove the cabinet to complete drilling the pilot
holes into the concrete block. When complete,
place the cabinet against the wall.
6. Once you conrm the cabinet is level and square,
use Tapcon® 410 Stainless Steel 3/16” x 2‑3/4”
fasteners, with a ¼ stainless steel washer to secure
the cabinet to the wall.
INSTALLATION GUIDE
2”
inch
3
16
drill bit.
inch
3
16
3
2
4
x
inch Washer
1
4
INSTALLATION GUIDE
FASTENING CABINETS TOGETHER
As you install your Base and Wall cabinets, you should
fasten the cabinets together, along the front edge. This
will help reduce gaps between cabinets and maintain
alignment.
1. To secure cabinets together, a 1 ¼” stainless steel
screw is used. (Model #WSSS1.25-Screw Kit) Pre-drill
a 1/8” pilot hole in one end panel. Try to locate the
joining screws where they will not be visible, above
the drawer runner or behind the hinge plate.
2. Use clamps to hold cabinet panel in alignment.
Insert the screw through the pilot hole into the
second cabinet end panel – Be careful not to
countersink the head.
ADJUSTING DOOR ALIGNMENT
DOOR ALIGNMENT
WeatherStrong Cabinets feature a 6-way adjustable
hinge that will allow you to adjust and align all the
doors after installation
1. The center screw will adjust the door from side to side
2. The top and bottom screws in the hinge plate will
allow adjustment up and down
3. The back screw will adjust the door in and out
Please Note: These are soft-close hinges and will close
slower at rst.
TO REINSTALL THE DRAWERS
1. Extend both drawer runners all the way out of
the cabinet box
2. Carefully reengage the metal drawer box proles
on both sides
3. Once both proles are engaged about 1”
carefully push the drawer all the way into the
cabinet
1 inch
1
4
inch Pilot Hole
1
8
1
2
1
2
3