Installation Guide

weatherstrong.com 888-745-0004
7
IfyourdesignincludesaBarRiserKit(BRK),theinformationbelowwillhelpyoutoinstallit.
We recommend installing the cabinet legs after you have attached the bar riser to the base cabinet.
1. Lay out the cabinets that make up your kitchen and locate where the bar riser kits are going to be placed.
Note: Some BRK’s may overlap two cabinets, so follow your oorplan carefully.
2.AttachtheBRKtothebasecabinet(s)byliningupthebottomofthebarriserwiththebottomofthe
cabinet.
3.Attachthebarriserusing1-1/4”stainlesssteelscrews(WSSS1.25-ScrewKit)byscrewingfromtheinsideof
the cabinet through the rear hanging rails.
4. Once the BRK is attached, you can install the adjustable legs and level the cabinet/riser.
Bar Riser Kits
• 3/4”All-Weatherboard™compositematerialcabinetconstruction
• 4” deep by 36” high
• RequiresBTPforeldinstallationtomatchthecabinetdoors
Bar Risers are 4” deep by 36” high and are available in 3” width increments from 12” to 48”. When securely
attachedtothebackofa34½”highIslandBackbasecabinet,thetopoftheriserwillbeapproximately
40½”fromtheoor.Theseeldinstalledkitsfeatureafull-height¾”thickenclosedAll-Weatherboard™
compositematerialbackpanelandcanonlybepairedwiththeIslandbackbasecabinets.Thesekitswillturn
almost any base cabinet into a two-level bar.
Please Note: Exposed cabinet sides and backs MUST be covered by a matching end/island panel
BACK VIEW
36"
36" H
12"-49" W
4" D
Bar Riser Kit