Specifications

EN.PM.UM13 20140227 Earth Networks Weather Station Page 32 of 47

Installation

Jumper

Location
JumpersIllustration
RBB‐09‐XXXX–RBB‐10‐2085
SwitchIllustration
>RBB‐10‐2086
Weather

Station&
Lightning
System–4Pin
DataCable
Used
***This
Configuration
isNOTcovered
inthemanual
LX

Boost



2. Ifthejumperisnotintheappropriatelocation,relocatebypullinguponthe
jumper,movingtotheappropriatepins,andpushingdowngently.
Oriftheswitchisnotintheappropriatelocation,usingasmallpaperclip,
gentlypushtheswitchtotheappropriatelocation.







3.
ClosetheENNAbyreplacingthelidandthe2screwsoneachsideofthe
ENNA.

4. ConnectthePowerSupplytotheENNAandensurethatpowerisinOFF
position.

5. FindtheendofDataCablecomingfromyouroutdoorsensors.Placethe
connectorso
thatthearrowisontopandconnectittothebackoftheENNA,
underthe"DataCable"label,beingsuretomatchtheappropriate4Pinor8
Pinconnection.

6. Ifapplicable,connecttheoptionalAuxiliaryTemperatureSensortotheENNA.
WARNING!
Incorrectly assigning jumpers could result in damage to the equipment.
Please verify correct alignment before powering unit.