Installation Guide

Lay out, center and dig all four post holes 12”
diameter x 36” deep. Posts need to be no more
than 80” and 40” inside to inside.
*Note: For concrete mount installation skip to step 3.
40”
80”
1
Optional Concrete Mount Step
Place, square and trace each concrete post
mount. (R) Pre-drill concrete mount holes with
hammer drill at 4 1/2” depth with 3/8”
masonary bit.
Do not rush.
3
Place wedge anchors (S) into each hole and tap
into concrete leaving 1” above the concrete. Place
concrete post mount (R) over the installed
anchors and install washer and nut to each
anchor. Level and tighten with 9/16” socket.
Do not over tighten.
Optional Concrete Mount Step
4
36”
Install (4) 4x4x96” wood post (not
included) and level. Set your post, fill with
concrete leaving 3” from the top of the hole.
*Note: If not using the optional concrete mounts,
skip to step 6.
2