Instructions / Assembly

Step 2
Gently slide and snap the bracket covers over the rails.
Step 3
If needed, alter the post height and install the post caps.
Notes:
A non-ferrous metal blade can be used to cut the vinyl and aluminum at
the same time. Cut slowly and use all safety precautions.
Before installing the rails, ensure the aluminum is seated into the vinyl
rail properly. The large opening of the H-channel should be towards the
pickets.
If using vinyl sleeves, it is easier to mark the mounting bracket position
prior to installing them over wood posts or post mounts.
The bracket kits include two different size screws. The 1-1/2” screws are
used to install the black mounting bracket to the post. The 1” screws are
used to attach the rail to the black mounting bracket.
If you are using an optional post mount, use the 1” screws that come
with the post mounting hardware to install the mounting brackets.
Install the provided Foot Block on the bottom rail using the Foot
Block instructions.
Picket
Assemble the railing sections and slide the black mounting brackets over the vinyl rail ends.
Position the entire section between the posts aligning the bottom bracket with the line previously
drawn.
Center the mounting bracket on the post and install the bottom of the mounting bracket on
the drawn line.
Fasten the black mounting bracket to the post using the provided 1-1/2”screws, two on each side.
Fasten the vinyl rail to the mounting brackets using the provided 1” screws, two on each side of the rail. Fasten the vinyl rail to the mounting brackets using the provided 1” screws, two on each side of the rail.
This will secure the bottom rail.
Note: When installing the black mounting bracket ensure the screws fit
into screwhead cutouts.
This step will be repeated on the top rail.