Installation Guide

We’re happy to help. Call 1-855-224-9761
.
16
T&G Privacy with Mid-Rail - 110 MPH sustained winds
with gusts to 130 MPH
Step 1
Reinforce each post to at least
22" above ground with either an
aluminum insert (prior to installing
the fence) OR fill each post with
concrete (after installing the fence)
as shown in figure 1. If using
concrete, be sure to tape off the
rails to prevent it from flowing into
the rails.
Step 2
Install one #10 x 1" self-tapping
stainless steel screw into the top
and bottom of each 6" wide picket
to secure the picket to the top and
the mid-rails. Screws should be
placed no more than 1" from the top
or bottom of the rail. Be careful not
to over tighten the screws.
Step 3
Repeat step 2 to secure the pickets
between the mid-rail and the
bottom rail.
Step 4
Install a screw inside the post on
each side of the top rail as seen in figure 2.
High Wind Installation
32" min.
22" min.
Ground level
Top view of rail in posts
Place screw herePlace screw here
Place screws no more
than 1" from the edge of
the rail
Concrete or aluminum insert
(at least 54" tall)
12" X 36" post hole filled with
concrete
Figure 1
T&G Privacy with a Closed Spindle Top - 110 MPH sustained winds
with gusts to 130 MPH
Step 1
Reinforce each post to at least 22"
above ground with either an aluminum
insert (prior to installing the fence)
OR fill each post with concrete (after
installing the fence) as shown in figure
1. If using concrete, be sure to tape off
the rails to prevent it from flowing into
the rails.
Step 2
Install one #10 x 1" self-tapping
stainless steel screw into the top and
bottom of each 6" wide picket securing
it to the bottom and mid-rails. Screws
should be placed no more than 1" from
the top or bottom of the rail. Be careful
not to over tighten the screws.
Step 3
Secure every other spindle by installing
a screw through the top rail and
through the mid-rail.
Step 4
Install a screw inside the post on each
side of the top rail as seen in figure 2.
32" min.
22" min.
Ground level
Top view of rail in posts
Place screw herePlace screw here
Place screws no more
than 1" from the edge
of the rail
Concrete or aluminum insert
(at least 54" tall)
12" X 36" post hole filled with
concrete
Figure 2
Figure 1
Figure 2