Instruction manual
11
Operations
Using the Air Compressor
a. Check the object you intend to inate to nd the appropriate PSI.
b. Check the valve on the object you intend to inate to nd the appropriate valve
connector attachment for that specic object.
c. Open the latch on the valve connector and place the valve connector securely on a
valve stem, then close the latch.
d. Turn the Air Compressor on by ipping the Air Compressor Power switch.
e. Once the Air Compressor Gauge reaches the appropriate psi, or lbs/in
2
, turn the Air
Compressor off and disconnect the valve connector.
Using the DC Out Power
a. Plug an DC appliance into the DC outlet.
b. Press the DC Power switch to turn the DC power on.
c. Use the appliance freely, and remember to recharge the unit afterwards.
The compressor is designed for short term operation only. Operating the
compressor over an extended period of time will cause the compressor unit to
overheat, which could lead to re.
Allow the compressor to cool down for 10 minutes after each 10 minutes of con-
tinuous operation. There is an automatic shut-off if the compressor overheats.
Never leave the compressor unattended while in operation. The compressor
is capable of inating to 250 PSI. Do not exceed the recommended pressure
of either the compressor or the object being inated. If either recommended
pressure is exceeded, an explosion may result.
!
!