Installation Manual
©2015 KNAACK LLC
3
Latch System
The WEATHER GUARD® Latch System utilizes automotive grade latches in conjunction with high strength latch strikers to ensure maximum
security. The WEATHER GUARD® Latch System is designed to open with a single touch of the button, and close securely. Expect years of reliable
service from the WEATHER GUARD® Latch System with only minimal maintenance: Lubricate latch pivot points bi-annually with white grease. If
latch strikers are accidentally knocked out of alignment, simply use a mallet to re-align.
12V Electrical Access
WEATHER GUARD® Truck Boxes are equipped with a 12 volt
electrical access grommet for easy electrical accessory t-ups.
To use, simply cut along one or more perforations in the rubber
grommet and run wire through.
Level Holder
WEATHER GUARD® Saddle Boxes are equipped with brackets that
allow safe and easy storage of
levels. Install using
existing bolts.
Electrical
Access
Install holders
using existing
bolts
FEATURE OPERATION
Lock
Turn the key counterclockwise to
the locked position as indicated
on the lock bezel. When the
button is now pressed, it will
stay in the retracted or tamper-
resistant position until unlocked.
Unlock
Turn the key clockwise to the
unlocked position as indicated
on the lock bezel. Button will
pop out and is now ready
to release the latches when
pressed.
Lock System
The WEATHER GUARD® Extreme Protection™
Lock is designed to provide maximum
security, while providing ease of use and
years of reliable service. When in the locked
mode, the button remains retracted in a
tamper-resistant position. When the button is
pressed in the unlock mode, the latches are
activated and the cover opens.
STEP 2
Attach Box to Truck Bed
Attach mounting clamp, bolts and washers as shown in
gure to the right. Start with slot at drivers side front and
work clock-wise until all four clamps have been installed.
End Panel Slot
Mounting Pad
Mounting
Clamp
Bed Lip
Fender
Washer
5/16"-18 x 2-1/4"
Hex Head Bolt
• Mounting clamp bolt may be difcult to turn due to
the “lock nut” feature. Apply a small amount of grease
to bolt threads prior to installation to ease assembly.
Note: