Installation Manual

©2015 KNAACK LLC
2
TOOLS REQUIRED
PARTS LIST
Tray with Dividers
Level Holder Brackets
(saddle box only) Rubber Mounting Pads (4) Fender Washers (4) Mounting Clamps
(4) 5/16"-18 x 2-1/4"
Hex Head Bolts (2) Keys
• Ruler• 1/2" Ratchet Wrench
ALUMINUM BED UPFIT KIT PARTS LIST - 32-0242
(4)
Vinyl Tape
(1)
Zinc Rich Primer
Note: The rubber mounting pad
comes as a single piece and must be
separated into two pieces, one for
each side of the truck.
INSTALLATION INSTRUCTIONS
Note:
STEP 1
Locate Box in Truck Bed
Place rubber mounting pads on bed rails. Place box into position on top
of mounting pads. Use ruler to ensure box is centered in truck bed and
that cover opens fully without interference.
Note: Check clearance with cover open
Rubber
Mounting Pad
Rubber
Mounting Pad
Use vinyl tape as a barrier between the mounting clamp and
truck bed. Follow same instructions if mounting with a “J” bolt.
ALUMINUM TRUCK BED INSTALLATION:
• If the truck bed is constructed of aluminum,
use zinc rich primer to coat drilled holes.
• If the pickup is tted with a plastic drop-in
bed liner, it may need to be drilled, trimmed,
or cut for proper installation of truck box.
• Truck box cover may not properly latch until
box is fully bolted to truck bed in (4) places.
• Because truck bed congurations vary, (6)
mounting slots have been provided, to ensure
the use of (4) mounting clamps.
• Periodically check tightness of mounting
clamps to ensure proper attachment.
• Use touch-up paint on any drill holes to
prevent oxidation.
• Install boxes with vehicle parked on level
ground.