Product Manual
5
WWW.WEATHERGUARD.COM
2. Route Harness to Truck Bed
a. Route the new harness between the rear bumper and the knock out hole in the front of
the truck bed. It is usually easiest to follow the path of an exisng wiring harness along
the frame of the truck (recommend driver side). Secure the new harness to the truck in
a few locaons using the zip es supplied.
3. Route Harness Into the Truck Box and Connect
a. Remove the knock-out plug from the back of the truck bed, feed the harness end into
the truck bed and then through the grommet in the side of the truck box. Inside the
truck b
ox, connect the 2 pin connector to the light bar and tuck the excess wiring inside
the gas spring guard.
4. Check the Funconality
a. With the lid open, LEDs should be lit. Close the lid approximately ¾ of the way and
confirm LED lights turn off.