Installation Manual

1. Turn off the switch button to stop the vacuum cleaner.
2. Hold the vacuum cleaner (preferably hold the handle position) so
that the ash storage cavity faces downwards. The dust guide duct
inside the suction port will prevent dust from leaking from the suction
port. Rotate the dust cup to move the ash storage cavity away from t
he body, and disassemble accordingly.
3. Rotate the filter frame out of the body, and separate the Hypa from
the outer filter to clean the dust.
4. Beat the filter rack to clean it up. Then clean the ash storage cavity
and filter rack with clean water and let it air dry.
Note：Clean the ash storage cavity and filter frame with clean water,
do not use soap or other cleaning agents. This will damage the filter
frame. If the filter frame or ash storage chamber is damaged, it should
be replaced immediately.
5. After the ash storage cavity is emptied, cleaned and air-dried, it can
be put into the filter rack again and the ash storage cavity is installed.
Put the filter rack into the ash storage chamber again.
First insert the body part into the tail opening of the ash storage
.